Milling cut for rounding the tabletop
75.60 ₴
The service concerns the manufacture of a radius on the corner of the tabletop. Namely, on the side where there is an oval (R3, R6, etc.).
WARNING! After performing this service, the output from the cutter remains.
In the case of crimping such rounding, the recommended radii are:
- external - R60 - edge thickness 1; 1.5; 2 mm (width 41, 42, 43);
- internal - R120 - edge thickness 1; 1.5; 2 mm (width 41, 42, 43).
